工商區上午落單下午貨到 訂購表格下載適用於 Laser Printer :
適用於 MFC Printer :
約17,000張
香港及九龍區 工商區免費送貨
How do I replace the drum unit?
Follow the procedure below to replace drum unit.
Caution While removing the drum unit, handle it carefully because it may contain toner. DO NOT use flammable substances or any type of spray to clean the inside or outside of the machine. Turn off the printer power switch. Press the front cover release button and then open the front cover. Hold the green handle of the drum unit. Lift the drum unit up and then pull it out until it stops. Release the gray lock lever (1) that is on the left side of the printer. Pull the drum unit completely out of the printer using the green handles on the drum unit. Caution We recommend that you place the drum unit on a clean, flat surface with a piece of disposable paper underneath it in case you accidentally spill or scatter toner. Handle the toner cartridge carefully. If toner scatters on your hands or clothes, wipe or wash it off with cold water at once. Hold the handles of the drum unit when you carry it. DO NOT hold the sides of the drum unit. Hold the handle of the toner cartridge and pull it out of the drum unit. Repeat this for all the toner cartridges. Caution To prevent damage to the printer from static electricity, DO NOT touch the electrodes shown in the illustration. Caution To avoid print quality problems, DO NOT touch the shaded parts shown in the illustrations. Unpack the new drum unit and remove the protective cover. Caution Wait to unpack a drum unit until immediately before you put it in the printer. Exposure to direct sunlight or room light may damage the drum unit. Hold the handle of the toner cartridge and slide the toner cartridge into the drum unit. Make sure that you match the toner cartridge color to the same color label on the drum unit, and make sure that you fold down the toner cartridge handle (1) once the toner cartridge is in place. Repeat this for all the toner cartridges. Put the drum unit back in the printer as follows. Make sure that the gray lock lever (1) is in the up position and put the drum unit in the printer. Push down the gray lock lever (1). Note When you put the drum unit in the printer, match the green guides (1) of the drum unit handle to the green arrows (2) on both sides of the machine. Push the drum unit in until it stops. Close the front cover.
To prevent damage to the printer from static electricity, DO NOT touch the electrodes shown in the illustration.
To avoid print quality problems, DO NOT touch the shaded parts shown in the illustrations.
When you put the drum unit in the printer, match the green guides (1) of the drum unit handle to the green arrows (2) on both sides of the machine.
When you replace the drum unit with a new one, you need to reset the drum counter by completing the following steps:
