工商區上午落單下午貨到 訂購表格下載For BROTHER Laser Printer :
FAX2850, MFC4800, MFC9180
約 8,000頁 （以5%覆蓋率列印A4紙張）
香港及九龍區 工商區免費送貨
How do I replace the drum unit?
To replace the drum unit follow the instructions listed below:
Caution Do NOT use flammable substances or any type of spray to clean the inside or outside of the machine. Doing this may cause a fire or electrical shock. Caution Just after you have used the FAX/MFC, some internal parts of the machine are extremely HOT! When you open the top cover of the FAX/MFC, never touch the shaded parts as shown below: Open the top cover. Remove the used drum unit. Place the drum unit on a drop cloth or large piece of disposable paper to avoid spilling and scattering the toner. Gently turn the lever on the toner cartridge forward until it stops. Pull the toner cartridge out of the used drum unit, and keep it in a safe place. Place the used drum unit into the aluminium bag and discard it according to local regulations. Note Wait to unpack the new drum unit until immediately before installing it into the FAX/MFC. If an unpacked drum unit is subjected to excessive direct sunlight or room light, the unit may be damaged. Handle the toner cartridge and the drum unit carefully because they contain toner. If toner scatters and your hands or clothes get dirty, immediately wipe or wash with cold water. Discard the used drum unit according to local regulations. If you are not sure of them, call your local Sanitation Department. Be sure to seal the drum unit tightly so toner powder does not spill out of the unit. When discarding used drum units, keep them separate from domestic garbage. Caution Do NOT remove the clear plastic starter sheet! Reinstall the toner cartridge into the new drum unit. Gently turn the lever on the toner cartridge clockwise until it stops. Holding the new drum unit by its handles, install it. Close the top cover. The FAX/MFC will eject the clear plastic starter sheet automatically.
Do NOT use flammable substances or any type of spray to clean the inside or outside of the machine. Doing this may cause a fire or electrical shock.
Open the top cover.
Remove the used drum unit. Place the drum unit on a drop cloth or large piece of disposable paper to avoid spilling and scattering the toner.
